Toyota Yaris: Emission inspection and maintenance (I/M) programs
Some states have vehicle emission inspection programs which include OBD (On Board Diagnostics) checks. The OBD system monitors the operation of the emission control system.
■ If the malfunction indicator lamp comes on
The OBD system determines that a problem exists somewhere in the emission control system. Your vehicle may not pass the I/ M test and may need to be repaired. Contact your Toyota dealer to service the vehicle.
■ Your vehicle may not pass the I/M test in the following situations:
● When the battery is disconnected or discharged
Readiness codes that are set during ordinary driving are erased.
Also, depending on your driving habits, the readiness codes may not be completely
set.
● When the fuel tank cap is loose
The malfunction indicator lamp comes on indicating a temporary malfunction and your
vehicle may not pass the I/M test.
■ When the malfunction indicator lamp still remains on after several driving trips
The error code in the OBD system will not be cleared unless the vehicle is driven 40 or more times.
■ If your vehicle does not pass the I/M test
Contact your Toyota dealer to prepare the vehicle for re-testing.
General maintenance
Listed below are the general maintenance items that should be performed at
the intervals specified in the “Owner’s Warranty Information Booklet” or “Owner’s
Manual Supplement/Scheduled M ...
See also:
Installation of a mobile two-way radio system
As the installation of a mobile two-way radio system in your vehicle could affect
electronic systems such as multiport fuel injection system/sequential multiport
fuel injection system, electronic ...
General repair instructions
1. WORK PRECAUTIONS
(a) VEHICLE PROTECTION.
(1) When welding, protect the painted surfaces, windows, seats and carpet with
heat resistant, fireproof covers.
(b) SAFETY.
(1) Never stand in a ...
Body panel sealing areas
HINT: 1) Prior to applying body sealer, clean the area with a rag soaked in silicone
remover.
2) If weld-through primer was used, first wipe off any excess and than coat with
anti-corrosion prime ...
